Dekolink Wireless Ltd., 16 Bazel St., Qiryat-Arieh Petah-Tikva Israel, 49510
Tel: 972-3-9180-180; Fax: 972-3-
190
-
9180
Email: [email protected]
detects the amplitude and sends a feedback signal to a voltage variable attenuator which attenuates
the signal level so that the output power of the amplifier does not exceed the preset limit. The LED on
the amplifier illuminates when the power output of the amplifier is within the set limit (either when the
AGC is On or OFF).
The switch on the RF amplifier enables the AGC function. If the AGC is disabled then the amplifier
gives maximum gain
.
AGC AND GAIN CONTROLS
The AGC ON/OFF and GAIN SETTING functions for the up link path are reached by opening the
small slide door located on the Booster left side, adjacent to the BASE antenna port. For the down
link path the door is on the right side adjacent to the MOBILE antenna port.
RF Power LED
: The LED illuminates when the output power exceeds the AGC Set
.
AGC ON / OFF Switch
: When OFF the amplifier works with its highest gain (AGC Function
OFF). When set to ON (AGC Function ON) the amplifier power output cannot exceed the set limit.
Gain setting
: By using the rotary knob, the attenuation can be adjusted in 2 dB
steps.
;
Web site:
www.dekolink.com
Rev 0 02/03 Page 5 of 9
