14
Controls
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Description of control panel
The hood is equipped with a
“TOUCH”
device to control the
lights and speed.
For the correct use please carefully read the intructions
below.
Automatic start-up function
The hood is equipped with a temperature sensor which
activates the motor to the first suction speed (power) in the
event that the room temperature in the surrounding area is
higher than 70°C.
The user may switch off or modify the suction speed (power)
(
see paragraph “suction speed (power) control”
).
Suction speed (power) control
The suction speed (power) is cyclical depending on the
speed sequence “stand-by – 1-2-3-4- Stand by -1-2-...”
therefore every time the
T1
button
is pressed on the control
panel, the suction speed (power) is increased by one level,
in order to switch off (stand-by) if the button is pressed
again when the hood is in suction speed (power) 4.
The hood may be switched off (stand-by) while the hood is
set on any speed by holding down the
T1
button on the
control panel for a bit longer (more than 3 seconds).
The hood's suction speed (power) may be determined as
the control panel is equipped with a LED light that changes
colors as follows, depending on the suction speed (power):
Hood in stand-by:
LED LIGHT SWITCHED OFF
1st suction speed (power)
-GREEN LED LIGHT
2nd suction speed (power)
– ORANGE LED LIGHT
(amber)
3rd suction speed (power)
- RED LED LIGHT
4th suction speed (power)
- RED LED LIGHT
(FLASHING)
Note:
The 4th suction speed (power) stays on for 5 minutes,
after which the suction motor will position itself on the 2nd
speed.
If pressed again, the suction motor will switch off (stand-by).
Grease filters need cleaning:
FLASHING GREEN LED
light (read instructions found under “Reset and configuration
for filter saturation signal”)
Coal filters must be cleaned or replaced:
FLASHING
ORANGE (amber) LED light (read instructions found under
“Reset and configuration for filter saturation signal”)
Note:
The reset procedure may be activated by both the
control panel and the remote control.
Center light check
The center light may be switched on and off by pressing the
T2
button on the control panel.
Side light check (when scheduled)
The side lights may be switched on and off by pressing AND
HOLDING DOWN the
T2
button on the control panel.
Reset and configuration for filter saturation signal
Switch on hood to any speed (see above paragraph
“Suction speed (power) selection”)
Reset grease filter saturation signal (FLASHING GREEN
LIGHT on control panel)
First proceed with filter maintenance as described in
corresponding paragraph.
Press and hold down (for more than 3 seconds) the
T1
button on the control panel, the LED light will stop flashing
indicating that the signal reset has been carried out, the
hood will switch off.
Reset coal filter saturation signal (FLASHING ORANGE
(amber) LED light)
First proceed with filter maintenance as described in
corresponding paragraph.
Press and hold down (for more than 3 seconds) the
T1
button on the control panel, the LED light will stop flashing
indicating that the signal reset has been carried out, the
hood will switch off.
Coal filter saturation signal disactivaction (for particular
applications)
Switch off hood (see above paragraph “suction speed
(power) selection”).
Press and hold down (for more than 5 seconds) the
T1
button on the control panel, the LED light will start flashing
GREEN indicating that the coal filter saturation signal has
been disactivated.
In order to reactivate the coal filter saturation signal, repeat
operation, the LED light will flash ORANGE (amber)
