ELICA EVL430S3, Инструкция по использованию, уходу и установке

Страница: 9 / 32

9
Complete Installation
• For non-vented (recirculating) installations only, install
charcoal filters over metal grease filter�
See the “Mainteinance” section�
• Install metal filters� See the “Mainteinance” section�
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house
fuse blown�
• Disconnect power supply� Check that wiring is correct�
To get the most efficient use from your new range hood,
read the “Mainteinance” section.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.
Description of the Hood
5
4
1
3
2
1. Blower and light controls
2. LED lamps
3. Grease filter handle
4. Grease filters
5. Duct covers
Control
A B
A. Light button
B. Blower button
Operating the light
The Light On/Off button (A) controls both lights�
Press once for turning On soft light and the button sun
icon lightens with the bottom half of the edge slightly�
Press again for regular light and the button will be
completely illuminated�
Press a third time to turn Off the light, the whole
button light turns off�
Operating the blower
Press the button (B) to turn On the hood on low
speed, the icon and right low corner of the edge on
button will be illuminated�
Press a second time for medium speed, the icon and
the lower half of the edge on the button enlightens�
Press again to high speed and ¾ of the edge on the
button will illuminate�
Press the button a fourth time to activate Boost speed
for five minutes (the full icon and edge will be illumi-
nated) and then, automatically switch to high speed�
Press the button a fifth time to turn Off the blower and
button lights�
Change light color
With lights and motor turned Off, press and hold light button
for 3 sec, both buttons will fully illuminate on the current light
color� The buttons can be used to select desired color (Light
<< button backwards, Blower button forward >>)
Available light colors are white (default color), blue, green or
red� To set color, choose one and press both buttons at the
same time�
Sound
To enter sound mode, with lights and motor turned Off
press both buttons at the same time and the upper left
corner of the light button will illuminate with white light� The
buttons can be used to select desired sound (Light <<button
backwards, Blower button forward>>)�
Available feedback sounds are regular beep, soft beep and
mute� As the regular and soft beep are selected, the hood
will reproduce each sound� When mute is selected, upper left
corner of the light button will illuminate with red light� To set
sound, choose one and press both buttons at the same time�