10
Electrical Connection
I
WARNING
ELECTRICAL SHOCK HAZARD.
I
WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR
ELECTRICAL SHOCK.
1
Disconnect power.
2
Remove terminal box cover.
3
Remove the knockout in the terminal box cover and install
a UL listed or CSA approved
1
⁄
2
” strain relief.
A
B
C
A.
Knockout
B.
Junction box cover
C.
Junction box cover screws
4
Run home power supply cable through strain relief, into
terminal box.
A
B
C
D
E
D
A. Home power supply cable
B. UL listed or CSA approved
strain relief
C. Black wires
D. UL listed wire connectors
E. White wires
F. Green (or bare) and
yellow-green ground wires
2
Use UL listed wire connectors and connect black wires
(B) together.
3
Use UL listed wire connectors and connect white wires (A)
together.
I
WARNING
ELECTRICALLY GROUND BLOWER.
CONNECT GROUND WIRE TO GREEN AND YELLOW
GROUND WIRE IN TERMINAL BOX. FAILURE TO DO SO
CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
4
Connect green (or bare) ground wire from home power
supply to yellow-green ground wire (D) in terminal box
using UL listed wire connectors.
5
Tighten strain relief screw.
6
Install terminal box cover.
7
Check that all light bulbs are secure in their sockets.
8
Reconnect power.
Complete the Installation
Duct cover installation
• Attach the upper duct covers using the installation screws
shown in the figure.
B
A
C
A.
Upper duct covers
B.
4 - 3.5x6.5 mm installation screws
C.
2 - 2.9x3 mm screws
