ELICA EGL430SS, Инструкция по использованию, уходу и установке

Страница: 12 / 40

12
Controls
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Description of control panel
A B C D E F
A - Lighting: dim lighting / full lighting /off (loop control) -
Works even with hood in stand by and/or drawer closed.
B - Set Fan in Stand by (LED on the lower side of the
display ON).
C - ON/OFF Timer for selected speed (visualizes the speed
selected and flashing LED on the lower side of the
display).
This knob permits the operation of the cooker hood for
a established period:
20 minutes if the speed selected is 1
15 minutes if the speed selected is 2
10 minutes if the speed selected is 3
5 minutes if the boost speed P is selected.
D - Display showing: fan speed ( 1-2-3-P ), filter saturation
indicator ( F for metal filter, C for charcoal filter)
Note: if in posses of the Remote Control (see paragraph
"List of Part and Accessories") the display shows a
flashing "
b " this to indicate that the remote control
battery must be replaced.
When the led in the lower right side is on, it indicates
that the cooker hood is ready for operation (“standby”
position), the flashing LED indicates that the timer has
been activated for selected speed.
Warning!
The Charcoal filter saturation function is not activated.
In order to activate the charcoal filter saturation
indicator, press buttons E and F simultaneously for 3
seconds. Initially, only letter F will be displayed, then
after the 3 seconds have passed, letter C will be
displayed as well, indicating that the carbon filter
saturation control system is active.
To switch off the system, re-press the same two buttons:
letter C appear on display and after 3 seconds it
disappears and the device will be switched off.
E - Knob to decrease the speed: from boost speed P to
speed level 1 .
F - Knob to increase (standby) speed to boost speed P .
Attention! Boost speed P lasts 5 minutes after which the
cooker hood automatically sets the speed to level 2
(suction power).
Controlling the range hood with sliding glass:
Closing the glass, all selected speed and lights switched off.
Hood retains last speed (except P-boost-speed) setting
when glass is closed and re-opened.
If the hood fails to operate correctly, briefly disconnect it
from the mains power supply for almost 5 sec. by pulling out
the plug. Then plug it in again and try once more before
contacting the Technical Assistance Service.
Warning!
Always press the fan off button A before disconnecting the
hood from the mains supply.
Reset filter saturation signal
Press knob B for about 3 seconds.
The letter F and/or C will disappear from the display.