background image

 

21 

Maintenance of the remote control

 

 

Cleaning the remote control:  

Clean the remote control with a damp cloth and a neutral 
solution of detergent without abrasive substances. 
 

Changing the battery:   

• 

Open the battery casing. 

•  Replace the flat batteries with 3 new 1.5 V type AAA 

batteries. 

 

Respect the polarity indicated in the battery casing when 
inserting the new battery! 

• 

Close the battery casing up again.  

 

Disposal of the batteries 

Ultimate disposal of the batteries should be handled according 
to all national laws and regulations. Do not place used 
batteries in your regular waste. 
Ultimate disposal of the batteries must be done safely

.

 

Contact your local waste management officials for other 
information regarding the environmentally sound collection, 
recycling, and disposal of the batteries. 
  

 

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

 

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  

Therefore, we recommend observing these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

 

Grease filter 

Fig. 2 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
Remove the filter holder frame by turning the knobs (

g

) 90° 

that affix the chimney to the cooker hood. 

 

Charcoal filter (filter version only) 

Fig. 3 
It absorbs unpleasant odours caused by cooking. 

The charcoal filter can be washed once every two months (or 
when the filter saturation indication system – if envisaged on 
the model in possession – indicates this necessity)   using hot 
water and a suitable detergent, or in a dishwasher at 65°C (if 
the dishwasher is used, select the full cycle function and leave 
dishes out). 
Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 

Assembly

 

Place the mat around the grease filter and fix it in place using 
the devices provided. 
Position the upper cap and fix it in place using the fixing pin. 
 
To disassemble, perform the steps in the reverse order. 

 

Replacing lamps 

The hood is equipped with a lighting system based on LED 
technology. 
The LEDs guarantee an optimum lighting, a duration up to 10 
times as long as the traditional lamps and allow to save 90% 
electrical energy. 
 
For replacement, contact the technical service. 
 
 

Содержание 69315977C













Отзывы: