30
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
M
M
a
a
n
n
u
u
a
a
l
l
9.5.4
Position and Focus
a. Ring image by looking at the screen ring internal / outside mark located near the lever
to adjust.
b. Ring in the center of the screen when you close Focus light mark will appear near the aiming
mark. Focus light mark the aiming mark to position the lever in the left / right or forward / back,
move or adjust.
c. Lever and forward / back, move the ring to sharpen focus. Focus bar in one focus, if correct,
will be displayed.
9.5.5
Measurement
a. Measurement button.
b. Upon completion of measurements at the bottom left of the screen displays the
measurement results. If the measurement is not normally a "RETRY" or "AGAIN"
will be displayed.
9.5.6
Repeated measurements
a. Repeated measurements are necessary.
b. When measuring every last measure of the displays
9.5.7
a. [PRINT] by pressing the touch button to print the measured results.
b. Depending on the user setup system mode is selected in different prints.
Keep the objective glass of the examinee side clean.
If it was stained, it may cause on ERROR or inaccurate measurements.
NOTE
After printing, the previous results will be automatically removed
when the next measurement.
Prints recorded by the heat, so when you need long-term storage
is recommended that you make a copy and drop.
