Installation and First Start-Up
- 18 -
7.3
Installation of the Sensor
In order to fasten the sensor head, two M3 must be used.
NOTE!
The correct distance sensor / magnetic tape is monitored and displayed by the LED on the
top resp. on the front sensor (depends on design). Distance not correct
LED glow red
The mounting tolerances given below are valid for both housing types
(standard version with fixed cable outlet or sensor housing with round connector).
7.3.1
Mounting Tolerances
Further, the following tolerances must be observed:
Table 1: Mounting tolerances
Tolerances
Magnetic tape type
AB20-50-20-2-R-11 and AB20-50-20-2-R-12
Ride height (distance to the tape)
0.1 … 1.5 mm
Pitch
The max. Distance 1.5 mm must not be exceeded at any position
Yaw angle
0 ° ±0.5 °
Roll
The max. Distance 1.5 mm must not be exceeded at any position
Lateral offset
±0.5 mm
Figure 7: Tolerances
0.
1
–
1.
5
mm
Ride height
Pitch
Yaw angle
Roll
Lateral offset
±0.5 mm
<±0.5 °
M
ax
. 1
.5
mm
M
ax
. 1
.5
mm
