Sutton House,
Berryhill Road,
Fenton
Stoke on Trent
Staffordshire,
ST4 2NL.
Class 1 Configuration
The wires in the mains lead are coloured in accordance with the following code:
GREEN/YELLOW: EARTH (E)
BLUE: NEUTRAL (N)
BROWN: LIVE (L)
Class
1
Configuration
As the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW (or coloured GREEN) must be connected
to the terminal in the plug which is marked with the letter “E” or by the earth symbol .
The wire which is coloured BLUE (or coloured BLACK) must be connected to the NEUTRAL
terminal which is marked with the letter “N”.
The wire which is coloured BROWN (or coloured RED) must be connected to the LIVE
terminal which is marked with the letter “L”.
Always ensure that the Mains Cord is fixed into the plug through the Cord Guard or Cable
Clamp, (plug wiring diagram above), and that the Cord Guard screws are tightened to clamp
the cord (outer sheath and inner coloured wires) into position in the plug. Make sure that
the plug top is also fitted securely.
This appliance must be protected by a 13 Amp fuse in a 13 Amp type (BS1363) plug. Should
you need to replace the fuse, use only a 13 Amp ASTA approved BS1362 fuse (13A).
OPERATIONAL GUIDELINES
It is important to ensure the correct Plug Adaptor is used when operating in a country not
using the UK 13 Amp socket system. If in doubt, consult a qualified electrician.
PARTS IDENTIFICATION
SPECIFICATION DATA
ELECTRICAL SAFETY
E459 HALOGEN OVEN
AC: 220V-240V ~50Hz 1400W
Thermostat: 65-250°C
Timer: 0-60 minutes
Container capacity: 12L
Extension Ring
Squeeze claws to close
THE EXTENSION RING
The stainless steel extension ring will increase the volume of the product
and allow larger food stuffs to be cooked
TO USE
Place the steel extension ring on the top of the bowl then place the oven lid is
placed on the ring
Care must be taken when handling the extension when the appliance
is in operation or has been operated as the ring will be very hot.
A QUICK GUIDE TO REMOVING THE WIRE RACK
Claws
Wire Rack
Use the claw to grab the Wire
rack.
We would suggest that this
is performed on the last bar as
shown to increase stability
