Manual operating of flash lamps FX PRO serie
www.elfo.com.pl
Page 5
2.
Acoustic signalling mode switch
The three-position switch controls acoustic signalling modes. To change operation mode
press the button consecutively. The round border of button shows present status of the
lamp.
Shines steadily – serie of pulsating sounds while lamp is
loading, and longer cue at the end.
Blinks – one long signal after the procedure of loading is
finished and the lamp is ready to flash.
Light off – acoustic signal is deactivated.
3.
Modelling light mode switch
Energy of modelling light is controlled. There are three modes available. Repeatedly
pressing changes operation modes. Its activity is connected with bulb switch mode (7). The
round border of button shows present status of the lamp:
Shines steadily
(100%)
– there is full power of modelling light
activated.
Blinks
(USER)
– there is power of modelling light set by user.
Light off
(proportion)
– flash energy and power of modelling
light change simultaneously from minimum to 100% with
proportion.
USER mode
. In order to enter the USER mode, press the modelling light mode button
(3) and hold it down until sound is audible (you can hear the sound regardless of acoustic
signalling mode). Halogen will be activates as well regardless of current modelling light
mode). Dot on display (5) disappears and the latest level of user mode is displayed. In order
to set a new setting, rotate control knob (12). Desired value is stored after 4 s and long
acoustic signal is audible. Then lamp is back to normal operation mode, and energy value is
displayed.
Status of
modelling
lamp
On
Blinks
Off
On
100%
doesn’t
extinguish
after the
flash
100%
extinguish
after the
flash
Off
B
links
USER
doesn’t
extinguish
after the
flash
USER
extinguish
after the
flash
Off
O
ff
Proportion
doesn’t
extinguish
after the
flash
Proportion
extinguish
after the
flash
Off
Results of related operation of
both switches (3) i (7) is shown in
the table.
