Elfa BUGEG95WCD, Инструкция по установке и эксплуатации

Страница: 6 / 19

Instructions for Installation
DIMENSIONS AND INSTALLATION FEATURES
Warning:
a) Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and
the adjustment of the appliance are compatible
;
b)The adjustment conditions for this appliance are stated on data plate
;
c) This appliance is not connected to a combustion products evacuation device. It shall be installed and
connected in accordance with current installation regulations. Particular attention shall be given to the
relevant requirements regarding ventilation.
The cooker is supplied with an anti-tilting chain to prevent the appliance
from tilting forward and accidental damage to the gas pipe. Take the
expansion with hook and make an adequate hole in the wall behind, at the
same height as the chain fixing area. Insert the plug into the hole and then
screw in the hook until it is firmly fixed to the wall. Fix the chain to the
hook. Adjust to level of the cooker inserting the feet provided.
For a situation where the appliance is between two cupboards and the anti tilt chain cannot be fitted we
suggest securing by screwing through the both sides of the cupboards into the sides of the cooker. The screws
should be
fitted as follows. Position the oven between the cupboards in it's final position, then mark the location of the
pilot hole inside the cupboard. Refer to the diagram below for the location of the pilot hole. Use 3.5mm
diameter drill bit to drill the pilot hole through the cupboard and both sides of the cooker. Before drilling,
check your measurements to ensure the pilot holes are located within the range specified in the diagram. A
drilled hole in the
side of the cooker which is outside the range specified may void the warrantee. Inspect cupboards thoroughly
before drilling to avoid damage to electrical wires or gas lines. Fix two 12 gauge x 40mm long self tapping
screws through the pilot holes inside both cupboards and into the side of the cooker.
Note! Screw length is based on cupboard thickness of 20mm, gap between cupboard and oven of 10mm.
Screw length could vary depending on cupboard material thickness and gap between oven and cupboards.
Note! The screws must be accessible for removal if the cooker requires service. Cupboards must not be built
over these screws.
Equipment type:
free standing (class 1)
Insulation class : class 1
THE MANUFACTURER DECLINES ANY AND ALL RESPONSIBILITIES FOR DAMAGES TO THINGS
OR INJURIES TO PERSONS OR ANIMALS DERIVING FROM INCORRECT INSTALLATION OR USE
OF THE EQUIPMENT.
Nominal volume of the oven
105 lt
5