Eleyus DWB 45025, Руководство по эксплуатации

Страница: 57 / 73

57
4. DISHWASHER INSTALLATION INSTRUCTIONS
4.1.
When positioning the dishwasher, place it in an area where dishes can be easily
loaded and unloaded.
4.2. Do not put the dishwasher in an area where the ambient temperature falls below
0°C.
4.3. Place the machine close to a water tap and drain.
4.4. Do not hold the machine by its door or panel to move the
dishwasher
.
4.5. Ensure the water inlet and outlet hoses are not squeezed or trapped and that the
machine does not stand on the electrical cable while positioning.
4.6. Adjust the feet so the machine is level and balanced. The machine should be
placed on the flat ground otherwise it will be unstable and the door of the machine will
not close properly.
5. WATER CONNECTION
5.1. Make sure that the water supply is suitable for installing a dishwasher. We
recommend fitting a filter to your water inlet supply to prevent damage to your machine
due to contamination (sand, rust, etc.) from indoor plumbing. This will also help
prevent yellowing and deposit formation after washing.
5.2. Use the new water inlet hose supplied with your machine, do not use an old
machine’s hose. If the hose used for machine connection is new or has not been used
for a long time, run water through the hose before connecting. Connect the hose directly
to the water inlet tap. The pressure supplied by the tap should be a minimum of 0.03
MPa and a maximum of 1 MPa. If the pressure exceeds 1 MPa, a pressure relief valve
must be fitted between the connection.
5.3. After the connections are made, turn the tap on fully and check for water leaks.
Always turn off the water inlet tap after a wash program has finished.
5.4. Note printing on the water inlet hose! If models are marked with 25°, the water
temperature may be max. 25°C (cold water). For all other models: cold water preferred;
hot water max. temperature 60°C.
УВАГА!
AN AQUASTOP WATER SPOUT PROVIDES THE PRESENCE
OF DANGEROUS VOLTAGE.
DO NOT DAMAGE IT OR ALLOW IT TO BECOME KINKED
OR TWISTED.
5.5. Connect the water drain hose directly to water drain hole or the sink outlet
spigot. If a special curved tube is included, the waste water can be discharged directly
into the sink, hooking the curved tube to the edge of the sink Drain hose should be
connected minimum 50 cm and maximum 110 cm from floor plane.