Page 8
Motion Detector Advanced User Manual
Factory Reset & Misc. Functions
Resetting the Motion Detector
If needed, the Motion Detector can be reset locally by following these steps.
Only do this when your Z-Wave controller is disconnected or otherwise unreach-
able. Beware that resetting your device will disconnect it from the system:
1. Remove the SENSOR COVER and confirm that your Motion Detector is
powered up.
2. Press and hold the BUTTON for at least 10 seconds then release. A flash-
ing LED INDICATOR indicates a successful factory reset.
3. The Motion Detector’s memory will be erased to factory settings.
Waking Up The Motion Detector
Because the Motion Detector is a battery powered device, it wakes up on reg-
ular intervals to give battery and other status updates to the controller, as well
as to accept configuration settings from the controller. This helps to extend
the battery life. The device can be forced to wake up to submit these reports
or accept new settings immediately by simply pressing and holding the BUTTON
for two seconds. The LED INDICATOR will flash once indicating successful wake
up.
Factory Reset & Misc. Functions
