16
3) Dose container, shake it up and wait until the product is fully dissolved, before using.
4.6 HAZARDOUS OPERATIONS
DANGER
When the flames are burning:
-
Do not unscrew the handle knob screw (Fig.1 # 8).
-
Do not unscrew the Safety Cap (Fig.1 # 2).
-
Do not bring flames or sparkles near the filling neck and the safety cap (Fig.1 # 2, 3).
-
Do not introduce metal objects inside the tank (Fig.5 # 50).
4.7 STARTING THE MACHINE
1) Connect the welder to a current outlet.
2) Mount the nozzle/burner tip onto the special torch or standard torch by screwing it until it is tight
enough or mount the adapter (for special torch) and then put the burner tip into the torch cone by
rotating and pushing it into place, until it is tight enough ( Fig 1 # 10, 11 ).
3) Set the power control knob at ZERO (Fig 1 # 4). Turn on the welder pressing the "-" mark at the three
point position switch (Fig 1 # 1). The green and red lights will be on (Fig. 1 # 12, 6).
4) Turn , rotate and set the knob ( Fig 1 # 4 ) until the point of the gas supply indicator (Fig 1 # 20)
corresponds within the min/max Lt/h levels using the following values established in either TABLE
2 or TABLE 2A.
5) Wait for approximately 2 or 3 minutes (or more) until you hear the gas being discharged from the
burner tip (Fig 1 # 11).
6) Light the flame.
7) In case of any indecision on the part of the operator, refer back to the Quick Start Guide at the
beginning of this manual.
