Eletrofisher Sum, Руководство пользователя

Страница: 5 / 16

5
Knob P serve to increase or decrease output power of going out
impulses in accordance with clock direction.
The electrofishing is quite simple, however, it may seem to
be very complicated at the first sight.
The most important is to meet all cable connections and the
electrofishing device . To connect correctly device we should
install first the button of steering on landing net and to connect
the high voltage cable into the landing net. The button is the
common PRESS-REALEASE button this means that in moment
of pressing device switches ON and makes possible fishing and
in moment of releasing the button the electrofisher switches OFF.
This button we install on landing net - we attach it with
isolation to landing net in distances 30-50 cm from end so that
we could easily operate the landing net and switch on the
electrofisher.
This button is connected with cables of steering output
power- if we press the button then the device switches ON- we
release the button then device switches OFF.
High-voltage cable - (up to 1200 Volt) we can install directly
to the hoop and to wind its rest on stick or what more comfortable
to place into the centre of plastic telescopic tube ( handle of
landing net).
To the socket OUT "+" of electrofisher we connect outer
cable which goes to the landing net. This must be installed on the
plastic landing net and the bare end of a cable must be fixed to
the metal (aluminium) ring of landing net. The other 2 cm bare
end we place in the socket OUT"+" .
To the outer socket OUT "-" we connect outer cable with
metal wire at the end ( mass/minus) and the metal copper end