elero VarioTec-868 DC, Руководство по эксплуатации

Страница: 11 / 15

20 | EN Ⓒ elero GmbH
Ⓒ elero GmbH EN | 21
3.5.4 Programming intermediate position
Requirement:
The blind is in the upper end position.
1. Press and hold the [
Pos ▼
] button.
2. In addition, press the [
DOWN/CLOSE ▼
] button until the
desired intermediate position is reached. You can correct
the position with the [
UP ▲
] button.
3. Release the [
Pos ▼
] button.
The intermediate position is now saved.
The LED flashes green three times.
You can also program the intermediate position with a pro-
grammed hand-held transmitter.
3.5.5 Programming ventilation position / Turn position /
Fabric stretching position
Requirement:
The blind is in the bottom end position.
1. Press and hold the [
Pos ▲
] button.
2. In addition, press the [
UP ▲
] button until the desired ven-
tilation position / turn position / fabric stretching position is
reached. You can correct the position with the
[
DOWN/CLOSE ▼
] button.
3. Release the [
Pos ▲
] button.
The ventilation position / turn position / fabric stretching
position is now saved.
The LED flashes green three times.
You can also program the ventilation position / turn positi-
on / fabric stretching position with a programmed hand-held
transmitter.
3.5.6 Approaching the intermediate position
Requirement:
The intermediate position is programmed.
The intermediate position can be approached only from the
top end position.
1. Press the [
DOWN/CLOSE ▼
] button twice briefly.
The blind travels to the stored intermediate position.
If no intermediate position has been programmed, the blind
travels to the lower end position.
Important:
When using blinds and the turning position is programmed
the blind slats are also turned.
If no turning position is programmed, the blind stops at the
intermediate position with closed blind slats.
You can also approach the intermediate position with a
programmed hand-held transmitter.
3.5.7 Approaching ventilation position / Turn position /
Fabric stretching position
Requirement:
The ventilation position / turn position / fabric stretching
position is programmed.
The turning position can be approached only from the
bottom end position.
1. Press the [
UP ▲
] button twice briefly.
The blind travels to the stored turning position.
You can also approach the ventilation position / turn positi-
on / fabric stretching position with a programmed hand-held
transmitter.