elero TempoTel 28 260.0001, Руководство по эксплуатации

Страница: 9 / 16

Deleting transmitter/channel settings
GB-15 GB-16
Deleting individual transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Open the front cover on the device and press the following
buttons simultaneously :
• Programming button P
• STOP button
2. Keep these two buttons pressed until the LED goes out briefly.
Deleting all transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Open the front cover on the device and press the following
buttons simultaneously :
• Programming button P
• UP button
• STOP button
• DOWN button
2. Keep these two buttons pressed until the LED briefly flashes
briefly 3 times.
GB
Programming radio channels
Programming a transmitter/channel
Prerequisite:
The receiver must be installed.
1. With pre-installed electric receivers, the fuse must be
disconnected and reconnected after a few seconds. The receiver
will remain in programming mode for approx. 5 minutes.
2. Position yourself in front of the roller shutter/blind with the
remote control in your hand.
3. Open the front cover of the device and press the transmitter
programming button P briefly. The roller shutter/blind will
start to move up and down. This will happen for approx.
2 minutes.
4. Select the desired channel using the Select button.
5. To define the keyboard layout, press the UP button on the
transmitter as soon as the shutter/blind begins to move
upwards (after approx. 1 second). The shutter/blind will come
briefly to a halt. As soon as the shutter begins to move again,
press the
DOWN button on the handheld transmitter.
The shutter/blind will stop.
The transmitter/channel has been successfully programmed.
Note: If more than one receiver is connected to the same mains
lead, all of these will be in programming mode
simultaneously. The shutters/blinds will begin to move up
and down “at random”. The longer you take to carry out the
programming, the larger the offset becomes.
Individual channels can now be assigned to the relevant
receiver.
The brief UP and DOWN movements can be stopped by
pressing the
STOP button on one of the pre-programmed
hand-held transmitters briefly.
Channel assignment /modification can now be carried out
without you having to disconnect individual channels.
If the shutter/blind moves in the wrong direction, the
transmitter must be deleted and re-programmed.
Programming additional transmitters
To programme additional transmitters in one receiver, please
proceed as follows:
1. Press the
UP , DOWN and programming button P on a transmitter
that has already been programmed in the receiver until the LED
goes out.
2. To define the keyboard layout, press the UP button on the hand-
held transmitter as soon as the shutter/blind begins to move
upwards (after approx. 1 second).
The shutter/blind will come briefly to a halt.
As soon as the shutter begins to move again, press the
DOWN
button on the handheld transmitter.
The shutter/blind will stop.
The transmitter/channel has been successfully programmed.