GB-24
www.elero.com
Approaching the intermediate position
Requirement
The transmitter/transmitter channel has been programmed. The
blind is at its upper end position.
1. Press the
DOWN
button briefly twice. The status display lights
up briefly.
2. The blind travels to the stored intermediate position. In the case
of venetian blinds, after reaching the intermediate position, the
slats turn automatically. If no intermediate position has been
programmed the blind travels to the lower end position.
Approaching the ventilation/tilting position
Requirement
The transmitter/transmitter channel has been programmed. The
blind is at its lowest end position.
1. Press the
UP
button briefly twice. The status display lights up
briefly.
2. The blind travels to the stored ventilation / tilting position. If no
ventilation/tilting position has been programmed the blind travels
to the upper end position.
Deleting positions/deleting transmitter
Deleting the intermediate position in the receiver
1. Press both the
STOP
button and the
DOWN
button.
2. Hold down this button combination for approx. 3 seconds.
The status display lights up briefly.
Deleting the ventilation/tilting position in the receiver
1. Press both the
STOP
button and the
UP
button.
2. Hold down this button combination for approx. 3 seconds.
The status display lights up briefly.
Deleting the transmitter channel in the receiver
1. Press both the
STOP
button and the programming button
P
(on the back of the device).
2. Hold down this button combination for approx. 6 seconds until
the status display lights up orange briefly and then red. In
