Commissioning
Condition:
The end positions of the awning, the roller shutter or the
venetian blind have been set, a transmitter has been
programmed, and the Lumero-868 has been loaded
(LED lights and/or flashes when a button is pressed).
Start programming mode
1.
Blind/shutter
runs up and
down for
2 minutes.
min. 3 sec.
elero
2.
3.
STOP
STOP
Press the -button
on the Lumero-868
immediately
after
the start of upward
travel.
Press the - button
on the Lumero-868
immediately
after
the start of
downward travel.
Programmed transmitter.
^
Programming Lumero-868
Charging the Lumero-868
The Lumero-868 is delivered in the discharged condition.
1. Place the Lumero-868 under a lamp for at least 30 minutes or
push the DOWN-button on the Lumero-868 for at least
3 minutes before starting up.
Note:
The travel keys have two levels.
The first level transfers energy from a built-in battery to the
energy store.
The second level activates the travel command.
Setting the mode (awning, protection against prying eyes,
roller shutter)
The Lumero-868 can be operated in three different modes.
The modes can be successively switched through..
The current mode of the Lumero-868 is displayed by means of the
flashing of the red LED.
The awning mode is set as standard in the delivery condition.
In the case of OEM versions, a different mode can also be set.
Awning mode
The awning is automatically retracted when the current measured
sun value changes from 1 to 0 (late evening) or when the current
measured light value changes from 0 to 1 (early morning).
Protection against prying eyes mode.
To keep the blind closed even in the evening, close the blind
manually using your hand-held transmitter or a timer.
The current transitions of the measured light values from 1 to 0
(late in the evening) or from 0 to 1 (early in the morning) will be
ignored.
The blind will remain closed throughout the night.
The switching commands such as tilting position (venetian blind)
or ventilation position (roller shutter) will be executed auto -
matically the next day.
Roller shutter mode
If the roller shutter is driven manually by a timer or the twilight
function to the lower end position, the light function (driving
according to set light value) will be switched off.
The current transitions of the measured light values from 1 to 0
(late in the evening) or from 0 to 1 (early in the morning) will be
ignored.
You can switch on the light function again in several different ways:
– the blind moves to the upper end position by means of a manual
UP travel command (button on the Lumero-868).
– the blind moves to the upper end position by means of an auto-
matic timer command.
– by switching the sliding switch from AUTOMATIC mode to
MANUAL mode and back to AUTOMATIC mode.
DOWN button
( )
UP button
( )
Multiple contact switch
(Threshold value)
^
There is a multiple contact switch inside the Lumero-868.
1. Set the multiple contact switch to 0 using a small screwdriver.
2. Keep the UP and DOWN button pressed for at least 3 seconds.
The current mode of the Lumero-868 is displayed by means of
the flashing of the red LED:
The operating mode is indicated by the flashing signal.
Red LED flashes 1x
W
Awning mode
Red LED flashes 2x
W
Protection against prying eyes mode.
Red LED flashes 3x
W
Roller shutter mode
The set mode is displayed at each radio transmission by the
flashing of the red LED (LED flashing pattern 1x per minute).
Set the multiple contact switch from 0 to a value selected by
yourself.
Change the mode
Note!
Support for the twilight function is dependent on
the software version of the receiver.
