elero MultiTel 2, Руководство по эксплуатации

Страница: 20 / 23

38 | EN Ⓒ elero GmbH
Ⓒ elero GmbH EN | 39
been programmed. If an intermediate position is not
programmed, the blind moves down to the bottom end
position (not if Combio Pulse is used).
Approaching the ventilation/tilting position
Requirement
The transmitter is now programmed.
The blind/shutter is at its lower end position.
1. Press the UP button briefly twice. The status display
lights up briefly.
2. The blind travels to the stored ventilation / tilting position.
If a ventilation/tilting position is not programmed, the blind
moves down to the bottom end position (not if Combio
Pulse is used).
4.6.7 Operation of transmitter with Combio JA Pulse
A Combio-867 / -868 / -915 JA pulse for exact setting of
the slats can be used with venetian blind drives. Press the
UP or DOWN key to move for the preset pulse time of the
Combio Pulse.
The user can change the pulse time. This is done by
pressing and holding the STOP and UP keys for 6 seconds.
The drive starts moving in short pulses. As soon as the
blind has moved the desired distance, release the UP key
then release the STOP key. The new pulse time is saved.
The new pulse time is equal to the total of all pulse times
while programming the pulse time. After 30 pulses the
Combio JA Pulse terminates programming the pulse time.
4.6.8 Deleting positions/deleting transmitters
Deleting the intermediate position in the receiver
1. Press both the STOP button and the DOWN button.
2. Press and hold this key combination for approx.
3 seconds. The status display lights up briefly.
Deleting the ventilation/tilting position in the receiver
1. Press both the STOP button and the UP button.
2. Press and hold this key combination for approx.
3 seconds. The status display lights up briefly.
Deleting the transmitter channel in the receiver
• Press both the STOP key and the programming button P
(back of the device).
3. Press and hold this key combination for approx.
6 seconds until the status display lights up briefly orange
and then red.
The channel (or the group) in the transmitter is also
deleted.
Deleting all the transmitters in the receiver
1. Press the STOP key, the programming button P (back of
the device) and the UP key and the DOWN key together.
2. Press and hold this key combination for approx.
6 seconds. The status display lights up orange-green
briefly twice, followed by red.
The channel (or the group) in the transmitter is also
deleted.
4.6.9 Expert settings
DIP switch 1 on the back of the device, under the cover:
OEM setting