EN | 3
Setting the threshold values
Insight the Lumero-868 you will find a multi-way switch for
setting the threshold value for light; this can be adjusted
using a small screwdriver.
Setting the threshold values at the Lumero-868
Step 0
light function is switched off /
change over the mode
Step 1
extend in low light level
minimum responsivity
Steps
2 - 9 and
A - E
13 Steps
Step 7
factory setting
(intermediate levels)
Step F
extend at a high level
maximum responsivity
Deleting the programmed Lumero-868
Press the - and the -button simultaneously.
The LED goes out. Wait until the LED lights up again after
approx. 3 seconds.
The lumero-868 is deleted.
Change the mode
There is a multiple contact switch inside the Lumero-868.
1. Use a small screwdriver to set the multi-way switch to 0.
2. Press and hold the
UP
and
DOWN
buttons for at least 3
seconds. Pressing the two buttons again switches to the
next mode.
The current mode of the Lumero-868 is indicated by the
transmit LED flashing:
Transmission LED flashes 1x
→
awning mode
Transmission LED flashes 2x
→
visual protection mode
Tansmission LED flashes 3x
→
roller shutter mode
The mode set is indicated at each radio transmission by
the flashing of the transmission LED (LED flashing pattern
every 3 minutes).
Set the multi-way switch back from 0 to a light value of your
choice.
Installation
Check whether a perfect radio connection exists between
the Lumero-868 and the receiver before installation at the
desired installation position.
Hinweis
Fix the Lumero-868 with the screws provided.
149,7
42
14,5
4,5
4,5
14,5
118,5
28
1,7
149,7
28
1,7
Vertical installation
position
Horizontal installation
position
Sensor-
surface
Sensor-
surface
Maintenance
The Lumero-868 is maintenance-free, but the cover must
be cleaned from time to time. Otherweise, light entry is limi-
ted and shortens functioning time.
Troubleshooting
Fault
Cause
Remedy
• Awning does
not move
out in sunny
conditions
• Threshold set
incorrectly
• Manual mode is set
• Poor radio connection
• Light sensor is dirty
• Sun threshold (level 0)
• Set correct value
• Set automatic mode
• Change the position of
the Lumero-868
• Clean light sensor
• Set appropriate level
x
© elero GmbH