Ⓒ
elero GmbH
EN | 25
24 | EN
Ⓒ
elero GmbH
Warning signal
Meaning and measures
1 x long
(approx. 1 s).
The signal sounds
with every actuation
Replacement of the battery pack
required. 2 years of operation
or 500 charging cycles of the
battery pack have been reached.
•
Change the battery pack.
2 x short
(within 1 s).
The signal sounds
once and with every
actuation.
Low charge status. The charge
status of the battery pack required
for reliable functionality has not been
reached.
•
Avoid further actuation of the drive.
•
If necessary, restore the mains
supply.
Table 6: Warning signals
DIP switch 2 can be used to set the warning signal for
replacing the battery pack. The warning signal for a low
battery level cannot be disabled.
Switch 2 OFF
The signal for replacing the battery pack sounds.
Switch 2 ON
The warning signal for replacing the battery pack is deacti-
vated. An acoustic signal is only emitted in the case of a low
battery pack charge level.
6.3 Automatic start-up
When automatic start-up is activated, ExitSafe activates
the motor when the charge status of the battery pack
has dropped to such an extent that only one complete
movement of the motor can be guaranteed.
Automatic start-up can be set using DIP switch 3.
Switch 3 OFF
No automatic start-up. An acoustic signal is emitted only in
the case of a low battery pack charge level.
Switch 3 ON
Automatic start-up activated. When the battery pack is low, a
warning signal sounds and the drive is controlled.
6.4 Shutdown and restart
Note the following points when switching off the power
supply over a longer period of time:
•
If automatic start-up is activated, the motor will be
automatically triggered after some time without the
mains supply. To avoid this, disconnect the battery
pack.
•
The battery pack will enter power saving mode after
several days without being recharged. ExitSafe is not
ready for operation in this state.
•
In order to be fully operational after the mains supply
has been switched on again, the battery pack must
first be charged for several hours.
6.5 Additional information
•
Charging cycles and operating times are recorded by
the battery pack itself. For this reason, after replacing
the battery pack, no further steps are necessary to set
up the control module for the new battery pack.
•
The power supply source for the motor is always the
battery pack. For this reason, operation of the motor
from the control module is not possible without a
battery pack.