elero AeroTec 28 140.0001, Руководство по эксплуатации

Страница: 8 / 17

Warnhinweise
Settings menu
SETTING menu
Im Menü EINSTELLUNG haben Sie folgende Möglichkeiten:
• SUN ▼ (if a sensor is connected)
• DELAY ▼ (only possible if expert mode is ON and a
sensor is connected)
• SUN ▲ (if a sensor is connected)
• DELAY ▲ ((only possible if expert mode is ON and a
sensor is connected)
• INTERMEDIATE POSITION
• CANOPY TENSION
• WINTER ON/OFF
• WIND CONTROL (if a sensor is connected)
• TIME END LIMIT/INTERMEDIATE POSITION/CANOPY
TENSION (only for pre-programmed switching or
blocking time)
• LIGHT END LIMIT/INTERMEDIATE POSITION/CANOPY
TENSION (if a sensor is connected)
• TEST MODE ON/OFF (if a sensor is connected)
• Language selection (GERMAN)
• SUMMER/WINTER (automatic clock adjustment for day -
light saving)
To make settings, press the OK button repeatedly until you reach the
menu level required.
SUN ▼ / SUN ▲
The threshold value for SUN ▼ is pre-set to 04 and for SUN ▲ to 03.
The brightness value can be set to values ranging between 01 (very
overcast) and 15 (direct sunlight).
The existing sunlight setting and the new setting to be made are
shown on the display. The field for the new sunlight setting flashes.
Settings menu
DELAY ▲ ▼ (only when EXPERT MODE is ON)
The delay time ▼ is pre-set to 3 min and the delay time ▲ is pre-set
to 15 min.
The delay tim ▼ indicates the period between the moment the
threshold setting SUN ▼ is exceeded and the control command is
executed.
This setting can be made manually.
The delay time p indicates the period between the moment the
sunlight reading falls below the pre-set threshold value
SUN
▲ and
the ‘retract ‘ control command is executed.
This setting can be made manually.
END LIMIT
The end limit position is described as the point at which the sun
protection system has reached the upper or lower limit position.
INTERMEDIATE POSITION
The intermediate position lies between the upper and lower limits
of the sun protection system and can be freely selected. The sun
protection system is adjusted into this position from the upper
position after programming.
Press the
DOWN
button
twice
in rapid succession to move to the
intermediate position.
When the system is in venetian blind mode, it is also possible to pro-
gramme a reversing position. In this case, this command will be auto-
matically executed following the intermediate position command.
CANOPY TENSION/REVERSE
The canopy tension/reversing position lies between the upper and
lower limits of the sun protection system and can be freely selected.
This function can be used to make the canopy of your sun protection
system taut.
In the case of venetian blinds, the blind slats are turned.
To do so, press the UP button twice in rapid succession.
14 | EN EN | 16