Page 10
Engineering Department PHONE: +39 0532 829 965 - FAX: +39 0532 829 177
E-Mail: [email protected]
Back to index
Use and maintenance manual
2. USAGE INSTRUCTION
ELENOS
Connected a 50
load or 50
antenna to the RF output, connect the
equipment into a mains supply (100÷240 VAC) with earth point. The
transmitter equipment is factory pre-set to 0.0 W.
Switch ON the power switch and the yellow V POWER led will light.
The Display will show:
After 3 seconds the green PLL LOCK led will light and the Display will
show an increasing bar, after a further 5 seconds the green ON AIR led
will light and there will be output power.
At this point the Display will show the next parameter for the transmitter:
•
Level Modulation (MOD > );
•
Forward Power (FRW 5.0W);
•
Reflected Power (RFL 0.1W);
instead for the receiver:
•
Level Modulation (MOD > );
•
Level Signal(50dBuV).
WAIT
WAIT
MOD >
FRW 8.0W RFL 0.0W
