10. Battery Replacement
1. When the battery voltage drops below the proper operating
range, the “ ” (low battery) symbol will appear on the LCD
display.
2. Before changing the battery, set the selector switch to the “OFF”
position. Open the battery compartment cover with a phillips
screwdriver.
3. Replace the old battery with a new one of the same type.
4. Close the battery cover and secure it with the screw.
Caution:
Properly dispose of the batteries as stated in your local
rules and regulations.
Note:
There are no fuses in this meter.
11. Maintenance
1. Before you open the battery cover, disconnect both test leads
and never use the meter while the battery cover is removed.
2. To avoid contamination or static damage, do not touch the circuit
board without proper static protection.
3. If the meter is not going to be used for a long time, take out the
battery and do not store the meter in high temperature or high
humidity environment.
4. While taking a current measurement, keep the cable at the center
of the clamp to achieve an accurate test result.
5. Repairs or servicing not covered in this manual should only be
performed by qualified personnel.
6. Periodically wipe the case with a dry cloth and detergent. Do not
use abrasives or solvents on the meter.
Elenco
®
Electronics, Inc.
150 Carpenter Avenue
Wheeling, IL 60090
(847) 541-3800
Website: www.elenco.com
e-mail: [email protected]
+
