-12-
Build the circuit shown. If continuing from the previous experiment
then close the Winscope program and run it again, to reset the
settings. Click on the
On-Line button
to activate, and turn on the
switch (snap part S1). Set Winscope to the settings shown below,
and move the lever on the adjustable resistor (snap part RV)
around to change
the waveform
and the sound. A sample
waveform is shown here, but the pattern and shape of the pulses
depends on the adjustable resistor setting.
Waveform
On-Line
button
Without Storage Mode
Winscope has a mode that can display multiple scans at the same
time, called
Storage mode
. Set the adjustable resistor lever to a
low-middle position, place Winscope in this mode, and watch the
results.
With Storage Mode
Storage
mode
CI-73_REV-E_051314.qxp_CI-73_Manual_072213 5/13/14 4:01 PM Page 13
