Elenberg SPT-7090, Инструкция по эксплуатации

Страница: 35 / 48

35
3. Install front panel
Place two supporters of the front panel into the slots,
along the direction of arrows to cover and clasp the
front panel. As show in right igure.
Cleaning the air ilters
Note: If dust is much more around the air conditioner,
the air ilters should be cleaned many times. After taking
off the ilter, don’t touch the in of indoor unit, in order to
avoid hurt your ingers.
1. Take down the air ilter
At the slot of surface panel to open an angle, pull the
air ilter downward and take it out.
2. Cleaning
To clean the dust adhering to the ilters, you can ei
-
ther use a vacuum cleaner, or wash them with warm
water (the water with the neutral detergent should
below 45 ºC).
When the ilters are very dirty (such as oil stain), and
dry it in the shade.
NOTE: Never use water above 45 ºC to wash, or it can
cause deformation or discoloration. Never partch it
by ire, or can cause a ire or deformation.
3. Reinsert the ilters
Reinsert the ilters along
with the arrow head, then
cover the surface panel
and clasp it.
1. Be sure that nothing obstructs the air outlet and intake vents.
2. Check that whether ground wire is properly connected or not.
3. Check that whether the batteries of air conditioner are changed or not.
4. Check that whether the installation stand of the outdoor unit is damaged or
not. If damaged, please contact the dealer.
1. Turn main power off.
2. Clean the ilter and indoor and outdoor units’ bodies.
3. Repaint the rubiginous place on the outdoor unit to prevent it from spreading.
CHECK BEFORE USE
MAINTAIN AFTER USE