Elenberg HT-410, Руководство пользователя

Страница: 27 / 36

27
original sound is 5.1CH format.
STEREO :The audio out format is stereo even if the original sound
is 5.1 CH format.
SURROUND: The audio out is virtual surround sounds (only for
5.1CH player).
OFF: Turn off downmix function. If playing 5.1CH discs or the unit
is connected with 5.1 channel amplifier, this item should be se-
lected. (only for 5.1CH player)
DIGITAL AUDIO SETUP PAGE
SPDIF OUTPUT
SPDIF OFF: no digital signal out( optical or coaxial output off ),
only analog audio output.
SPDIF ALL: If this item is selected, you can set up the following
RAW.
PCM ONLY: In SPDIF/PCM mode, setup PCM channel according to
your preference.
LPCM OUT
Select PCM frequency at 48kHz or 96kHz
Note: some amplifiers don’t support 96kHz sampling which will
effect the optical and coaxial output.
The initial factory setup is 48kHz.
DOLBY DIGITAL SETUP
DUAL MONO
Stereo: set audio output to the stereo output
L-mono: set audio output to the mono-left channel
R-mono: set audio output to the mono-right channel
Mix-mono: set audio output to the Mix mono channel
DYNAMIC
Select this to reduce the overall volume and still keep defined au-
dio sound.
CHANNEL DELAY PAGE
If the above setup disatisfies you, you can set the speaker dis-
tances in the real conditions. Press the key UP/DOWN to select the
speaker. Press the key LEFT/RIGHT to adjust the distance.
EQUALIZER
Seven EQ modes are available. You can select one according your
preference and the disc content .
3D PROCESSING
In PROLOGIC ON mode, the reverb mode setup is available. The
initial factory setup is off.
HDCD SETUP PAGE (NOT AVAILABLE FOR 2CH DVD and DVD without DTS)
You can select the digital filter at 44.1kHz or 88.2kHz. The initial fac-