background image

8

The professional choice for underfloor heating

Devilink

An easy to use touch screen panel which 
offers complete control over your entire 
heating system wirelessly from one 
central control.

eStat

Provides total control and flexibility 
when using your underfloor heating 

system. With the options of both manual

 

and fully programmable controls.

eDemist

An ultra thin self-adhesive heating 
pad that fits inconspicuously behind 
virtually any mirror keeping the mirror 
completely mist free.

Call 01473 27 66 80 to receive the latest 

underfloor heating catalogue  

eGuard Monitor

Monitors mats and cables for faults 

during installation.

e

Flex

Symptom

Probable Causes 

Corrective action

Floor does not heat

No power at controller

Check power supply

MCB tripped

Check the circuit is not overloaded

Thermostat not set correctly

Refer to thermostat instructions

eFlex not correctly connected with thermostat

Refer to thermostat instructions

Floor temperature sensor not connected

Refer to thermostat instructions

Faulty sensor / thermostat

Contact the eLine Helpdesk 08714 74 08 18

Heating element cut or damaged

Contact the eLine Helpdesk 08714 74 08 18

Floor warming all the time

Thermostat not set correctly

Refer to thermostat instructions

Floor temperature sensor not connected

Refer to thermostat instructions

Floor not getting warm enough 

Thermostat not set correctly

Refer to thermostat instructions

Floor sensor too close to heating element

Contact the eLine Helpdesk 08714 74 08 18

Contact the eLine Helpdesk with any questions on 08714 74 08 18

Troubleshooting

Copyright Elements, a trading division CJ Electrical (Ipswich) Limited. Registered in England no. 2895711

Tel: 01473 27 66 80

 

Fax: 01473 27 66 78

 

Email: [email protected]

 

Web: www.electricunderfloorheating.co.uk

Edison House, Unit 7,

 

Edison Close, Ransomes Europark,

 

Ipswich, Suffolk, IP3 9GU

 

United Kingdom 

Содержание eFlex









Отзывы: