12/
18
WARNING
When using this method to light your
fire table use heat resistant gloves
and follow the step by step
instructions. Failure to do so could
result in severe injury.
WARNING
DO NOT wear loose or flammable
clothing while lighting fire table.
WARNING
If burner flame goes out during operation, immediately
turn the control knob “OFF” and let the gas clear a
minimum of 5 minutes before attempting to re-light the
fire table.
LIGHTING INSTRUCTIONS
Using the Igniter
1. Read and understand all operating instructions before lighting. Ensure that all protective
film has been removed from stainless burn tray prior to lighting.
2. Burner control knob must be in the “OFF” position.
3. Connect natural gas source (see above pages).
4. Open the natural gas supply to the unit.
5. Push and hold igniter but t urn to create sparks.
6. While holding the igniter button with one hand, use your other hand to push and turn the control knob
to the “LIGHT” position to light the burner.
7. Keep the burner control knob pressed in for 15-30 seconds after ignition.
8.
If ignition does not occur in 30 seconds, turn control knob to the “OFF” position and turn gas off at the
source, wait 5 minutes until gas has cleared and repeat lightingprocedure.
9. After lighting, rotate the burner control knob counter clockwise to “Low” setting.
Observe flame, make sure all burner ports are lit. Flame height should be no higher than
13 inches tall.
10. Adjust the flame to the desired height with the control
knob.
Using a Long Match or Lighter
1.
Prior to lighting, use a shovel to move
the lava rocks for access to the burner.
2. Wearing heat resistant gloves, position the burning long
match or burning butane lighter near the side of the
burner. Do NOT lean over the fire table while lighting!
3.
Turn control knob counter clockwise to “LIGHT”.
4.
Remove long match/long butane lighter.
5.
After lighting, use a shovel and heat resistant
gloves to carefully move the lava rocks back
into their proper position.
6.
After lighting, rotate the burner control knob counter
clockwise to “Low” setting. Observe the flame, make sure
all burner ports are lit. Flame height should be no higher
than 13 inches tall.
7.
Adjust the flame to the desired height with the
control knob.
Please refer to the trouble shooting pages
for additional support, beginning on page 17.
Control Knob
