Element4 Modore 75H, Инструкция по установке и эксплуатации, Страница: 8 / 36

8
INSTALLATION MANUAL
Figure 4-3: Main burner ignition
Figure 4-2: Receiver (top - and side view)
Figure 4-1: Remote and ignition sign
4 Remote control with full electronic ignition
The unit is operated using a remote control (fig. 4-1). The ignition,
regulating the flame height and switching off is done using the
remote control, operating a receiver (fig. 4-2) in the control box.
The receiver and the remote control is powered by batteries.
4 pen lite (type AA) batteries are required for the receiver; 2
penlight batteries (type AAA) for the remote control. The life of
the batteries is about a year with normal use.
4.1 Adjusting the communication code
Before using the appliance, a communication code must be set
between the remote control and the receiver. The code is chosen
at random from the 65000 available codes. Therefore there is a
slim chance that other remotes in your area use the same code.
You must work as follows
Press the reset button on the receiver until you hear two beeps.
After the second longer signal, let go of the reset button. Fig. 4-2
Within 20 seconds, press the down arrow on the remote control
until you hear a sound signal. This is confirmation of the proper
communication.
4.2 Igniting the pilot light
Check that the control knob (A) is in the ON position. Fig 4-3. Press
the button on/off button of your remote control and continue to
hold down (3 to 5 sec.) until you hear two short beepes.
The ignition sign will appear at the top of the screen (fig. 4-1)
Now release the button. The ignitionprocedure is started.
NB:
If the pilot light doesn’t remain lit after 3 attempts you must
turn off the gas tap and warn your installer.
4.3 Igniting the main burner
After starting the pilot, knob B will automatically rotate counter
clockwise and the main burner will start burning. Fig 4-3. Always
wait 5 minutes after killing the pilot light before you start the
pilot flame again.
NB:
The pilot light must ignite the main burner, evenly and
without a thud, if it does thud, close the gas tap and warn your
installer.
4.4 Switching off the fireplace
You switch off the fireplace by pressing the on/off button, this
also turns off the pilot light! For a detailed description of the
E-save remote control, please refer to the E-save manual which
is included with the fireplace.
A B