59
OPERATING the FIREPLACE
Element4 Gas Fireplaces
European
Home
.com
Man - Manual Flame Height Adjustment.
You are now able to use the remote control. To increase the flame, the
©
button should be depressed. Pressing the
ª
button on
the handset will reduce the flame. The main flame may be lowered all the way down until it is off, leaving only the pilot ignited.
Fully Extinguishing the Appliance
From any heat setting, press the
OFF
button for a few seconds. This will cause the burner to fully extinguish.
The system has a safety interlock which will not allow the ignition until the interlock rests. This may take a few minutes.
The appliance should be shut off completely using the
OFF
button on the handset and not left on pilot only, except for
temporary use. This resets the system and all safety features.
Temp - Daytime Temperature mode.
The appliance must be in standby mode; pilot ignited. The room temperature is measured and compared to the set temperature.
The flame height is then automatically adjusted to reach the daytime set temperature.
d
Temp - Nighttime setback Temperature mode.
The appliance must be in standby mode; pilot ignited. The room temperature is measured and compared to the nighttime
setback temperature. The flame height is then automatically adjusted to achieve the nighttime setback temperature.
Timer mode.
The appliance must be in standby mode; pilot ignited. The Timer setting allows you to set 2 burner
Temp
times and 2 burner
d
Temp
times every 24 hrs.
For
d
Temp
to operate as a thermostat, TEMP must be set at 4°C or higher.
If the
d
Temp
setting is decreased to - -, the motor will turn the valve to the standby position in the moon times and await the
next burner
Temp
cycle.
Setting the Temperature.
Select either the
Temp
MODE or the
d
Temp
MODE by briefly pressing the
SET
button.
Hold the
SET
button until the TEMP display flashes.
Set the desired temperature with
ª
or
©
.
Press
OFF
to complete the program.
Setting the Timer.
Select Timer mode by briefly pressing the
SET
button.
Press and hold the
SET
button until the P1
is displayed, and the time flashes. Set the hour by pressing
©
and set the minutes by
pressing
ª
.
Briefly press
SET
button for the next burner cycle time.
Once all 4 times are set, press
OFF
to complete the programming.
MANUAL
KNOB IN
ON
POSITION
ON/OFF
SWITCH IN
ON
POSITION
MAIN VALVE
KNOB
IN
OFF
POSITION
Figure 69
.
Gas Valve