Element4 CLUB e Series, Руководство по установке

Страница: 9 / 12

INSTALLATION MANUAL
9
6 Installation method
This product has been designed to be free-standing.
If the product is to be installed into an open chimney or flue, it
is important that the chimney flue is blocked off to prevent any
up/down draughts and falling debris which could restrict the
airflow to the product.
Product size
The Ovation-e has the following dimensions to keep into
account (WxHxD): 488 x 1018 x 416 mm.
It is also important to ensure that the product has a minimum
clearance around it of 15mm, this is to ensure that the product
can circulate the required airflow to the heater unit.
The product should never be sealed into an opening with the
use of silicones or adhesives as this can alter the airflow and
hinder any further servicing of the product.
Please refer to technical specification table for further
information, with reference to measurements.
Heater unit cut out
This is a safety feature to safe guard against further damage to
the product.
If the airflow is restricted the heater will automatically turn off.
This can occur due to incorrect installation or obstruction. To
reset the heater function
• Isolate from main power supply
• Leave product to cool
• After suitable cooling down period, remove the obstruction
if obstructed andcheck installation
• After 10 minutes the thermo switch (cut-out) in the heater
will reset.
Please note
Both the effect fan and heater fan omit a low decibel noise,
both of which are normal operating characteristics.
7 Removing the Glass
To remove the top cover glass, begin by sliding the top section
away from you. This will release it from the keyhole slots. Then
remove the top section by lifting upwards, see
Figure 3
.
To remove the front glass panel, slide the glass upwards to
release it from the two highlighted channels on the left and the
right see
Figure 4
.
Reminder:
Do not remove the front glass without protection
when fire has been on! The frame as well as other parts of the
fireplace can become hot!
Figure 3 - Weghalen van de bovenplaat
Figure 4 - Removing the front window