Switching unit on/off
Put the lever on the chute (fig.11).pull the
starter cable evenly. The engine should
start up after 3-5 pulls. Put the lever at the
required speed and pull the driving lever
(fig 11) against the handle (fig.12).
Notice: if the engine is heated up, it is
possible to start up in the slow/fats
position.
With the driving lever tripped, the drive
will be off but the engines works on. The
engine may be switched off with the
switch in OFF position (fig.11).
When starting up the engine, the unit
should not be titled, only on the side
reverse to the operator if necessary for the
start.
◆
6.1 OPERATOR SAFETY INSTRUCTION
●
Do not use the machine until you have read the instruction manual carefully.
●
Observe any safety instructions included in the manual.
●
Be responsible to the others.
●
The unit is provided a foot-operated brake than stops the blades within 3 seconds after
the drive lever tripping. Never attempt stooping the unit or tilting the unit with blades
still rotating. Wait for the blades to come stand still by themselves.
●
If the blades get in contact with foreign objects stop the engine immediately and check
the unit with blades stopped for damage. Continue working with unit undamaged only.
●
Walk while working, do not run.
●
Always walk forwarder only. Never pull the unit walking backwards.
●
When working on a slope, always work across, never down and up. Be particularly
carefully when changing direction.
●
When travelling across no-grass areas and transferring the unit from the work area to
another one, the blades must not be operating.
●
Always holding tighten the clutch which allow the machine to be handle by your two
hands .
◆
6.2 STEP BY STEP INSTRUCTIONS
1. Fill in the fuel (see chapter assembly and first putting in operation
2. Clear any foreign objects from the land.
3. Spud the land until the soil is sufficiently loose.
4. Clean the unit thoroughly after every use.