26
CLEANING AND MAINTENANCE
Stop, remove plug from the
power supply and remove the
grassbox.
Always wear gardening gloves
when handling or working near
the sharp tines/blade.
Make sure all fasteners (screws, nuts, etc.) are
always fully tightened so that you can work safety
with the scarifier.
Check the grass box for wear and tear at
regular intervals
Replace any worn or damaged parts.
Regular care of your scarifier will not only
increase its service life but will also facilitate the
meticulous and easy scarifying of your scarifier.
Clean the scarifier with brushes or cloths. Do
not use any solvents or water to remove dirt.
Always switch off the motor and pull out the
power plug before carrying out any maintenance
and cleaning work.
The part most susceptible to wear and tear in
the machine is the blade. Check the condition of the
blade and its fastener at regular intervals. If the
blade is worn, it must be replaced or sharpened.
If the scarifier vibrates excessively, this means
that the blade is either not balanced correctly or has
been bent out of shape by knocks, in which case it
must be repaired or replaced.
Removing/Fitting Raker Tines
Stop, remove plug from the
power supply and remove the
grassbox.
Always wear gardening gloves
when handling or working near
the sharp tines/blade.
After Raking or Verticutting/Storage
Clean the exterior of the machine thoroughly us-
ing a soft brush and cloth. Do not use water, sol-
vents or polishes. Remove all grass and debris,
especially from the ventilation slots.
Turn the machine on its side and clean the
tine/blade area. If grass or dirt is compacted in
the tine/blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine. To save
space, fold up the handle fully.
Ensure the cables are not trapped when
folding/unfolding top/bottom handles. Do
not drop the handles.
The machine can be stored with the grassbox
Disassembled.
TECHNICAL DATA
Voltage - frequency
230-240 V ~ 50 Hz
Power consumption
1200 Watt
No-load speed
4500 min
-1
Working Width
330 mm
Working Depth
-3 / 4 / 8 mm
Volume collection bag
30 l
Teeth wire brush
48
Steel blades
9
Weight
11.2Kg
Degree of Protection
IP24
Noise emission values measured according to
relevant standard.
Acoustic pressure level LpA
82.1dB(A)
K = 3 dB(A)
Acoustic power level LwA
98 dB(A)
K = 3 dB(A)
ATTENTION !
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
must be worn.
Weighted root mean square acceleration according
to relevant standard. :
1.07 m/s
²
K = 1,5 m/s².
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
Содержание SCEE12002B
Страница 2: ...2 1 2 A B 3 4 5 6 7 8 7...
Страница 36: ...36...
