4. Measuring, Storage and Data Processing in DIRECT or APPL-BATCH mode
© ElektroPhysik
MiniTest 2500 - MiniTest 4500
15 of 73
4. Measuring, Storage and Data Processing in DIRECT or
APPL-BATCH mode
The following section describes:
the DIRECT mode
the APPL-BATCH mode
the structure of APPL-BATCH memory system
How to change from DIRECTto APPL-BATCH mode
How to select a scertain memory in APPL-BATCH mode
How to enter calibration values and limits
Special features of the APPL-BATCH memory system.
APPL
= Application memory
BATCH
= Memory for series of measurement
4.1 Switch on / start-up screen
Being switched on the unit will display the
measurement mode
of the last active series of
measurements (
„Batch“).
The model MiniTest 4500 offers two different working modes:
‘DIRECT mode’ and ‘APPL-
BATCH mode
’.
‘DIRECT mode’ is intended for quick occasional readings. Readings as well as the 6
statistical values (8 if limits have been set) can be shown on the display and printed by
pressing STATS’. The statistical analysis function can evaluate up to 9,999 readings.
In
‘APPL-BATCH mode’ a maximum of 10,000 single readings and approx. 500 separate
series of measurements can be stored in data memory individually. Single readings,
statistical values and the related histogram can be printed directly or at a later point.
Important note:
Working in APPL-BATCH mode (e. g. calibrating, measuring setting of limits etc.) is only possible,
when the display shows
„APPL BATCH“. Otherwise, activate the APPL-BATCH memory using the
keys APPL and BATCH. Also refer to Section 3.4 and 3.5.
Status line
Display Illumination
Battery-
level
Active
measuring
principle: Fe
Time
Number of
readings
Measuring
unit
Current
reading