Page 49
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
PSI 9000 DT Series
3.4.7
Switching the main screen view
The main screen, also called status page, with its set values, actual values and device status can be switched
from the standard view mode with three or four values to a simpler mode with only voltage and current display.
The advantage of the alternative view mode is that actual values are displayed with
much bigger characters
,
so they can be read from a larger distance. Refer to
to see where to switch the view
mode in the MENU. Comparison:
Standard status page
Alternative status page
Limitations of the alternative status page:
•
The set and actual values of power are not displayed and the set value of power is only indirectly accessible
•
The set value of resistance isn’t displayed and is only indirectly accessible
•
No access to the settings overview (MENU button) while the DC output is on
Rules for manual handling of the HMI in alternative status page mode:
•
The two rotary knobs are assigned to voltage (left knob) and current (right knob) all the time, except for menus
•
Set values input is the same as in standard status page mode, with knobs or by direct input
•
Regulation modes CP and CR are displayed alternatively to CC at the same position
3.4.8
The meter bars
Additionally to the actual values being displayed as numbers, a meter bar for U, I and P can be enabled in the
MENU. The meter bars are not displayed as long as resistance mode, i. e. U/I/R is activated. Refer to
to see where to enable the meter bars in the MENU. Depiction:
Standard status page with meter bar
Alternative status page with meter bar
Содержание PSI 9000 DT Series
Страница 2: ......
