23
Instruction Manual
EL 3000 A Series
EN
Date: 05-30-2017
Safety instructions
•
Only operate the device at a mains voltage as stipulated
on the type plate
•
Never insert mechanical parts, especially from metal,
through the air ventilation slots
•
Avoid any use of liquids of any kind in the proximity of
the device, they might get into it
•
Do not connect voltage sources to the device which
are able to generate voltages higher than 100V
DC
(80V
model) or 180V
DC
(160V model) or 460V
DC
(400V model)
•
In order to equip interface cards into the slot at the
rear, the common ESD provisions have to be followed
•
The interface card may only be plugged and unplugged
while the unit is completely switched off (mains switch
OFF)
•
Always observe limit and nominal values of the device
when connecting a voltage source or battery, as well
as when using the analogue interface
•
The DC input is not fused!
•
Pins AGND and DGND of the built-in analog
interface connector are internally wired to the
negative DC input (DC-). Thus it is not possible to
ground these pins the same time DC+ input is also
grounded!
General
About
Elektro-Automatik GmbH & Co. KG
Helmholtzstrasse 31-33
41747 Viersen
Germany
Phone: +49 2162 / 37850
Fax: +49 2162 / 16230
Web: www.elektroautomatik.de
Mail: [email protected]
© Elektro-Automatik
Reprint, duplication or partly, wrong use of this user
instruction manual are prohibited and might be followed
by legal consequences.
