1. Unpacking
Thank you for choosing the
elektraLite WW
fixture. For your own safety, please read this manual before
installing the device. This manual covers important information on installation and applications. Please
keep this manual for future reference. For the rest of the manual we are going to refer to the fixture as
elektraLite WW.
The
elektraLite WW
wash fixture uses 18 high powered leds, run in a balanced arrangement giving
incredible output. Please unpack the e
lektraLite WW
carefully and check whether it was damaged in
shipping.
The following item should be in the box with the fixture:-
2 part yoke
2 knobs for yoke
1 DMX 5 pin cable
1 Turnaround 3 to 5 pin cable
1 Turnaround 5 to 3 pin cable
1 IEC power cable
1 IEC jumper cable (for daisy chaining the power between fixtures)
Please handle the fixture with care at all times. Do not drop. Do not hit the front lens assembly.
2. Safety Instructions.
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning notes
written in this user manual. e
lektraLite WW
is a high voltage fixture. Be careful when dealing with high
voltages.
Please read this manual. If you do not read this manual and damages occur to the elektraLite WW,
then it could void the warranty.
During shipping, the e
lektraLite WW
may have been exposed to high temperature changes or humidity
changes. So, as a precaution, do not switch the
ElektraLite WW
on immediately. Condensation can
damage the
ElektraLite WW
so leave
the
ElektraLite WW
switched off until it has reached room
temperature. The
ElektraLite WW
is an
INDOOR
operational fixture. Do
not
operate this fixture
outdoors
or anywhere there is high
humidity.
The electric connection must carry out by a qualified person and it is absolutely essential that
the
ElektraLite WW
be
grounded
. So under no circumstances break off the ground pin on the Edison plug or
use the fixture where a ground is not present. A ground pin, like the fuse for the
ElektraLite WW
is there
for safety.
Always disconnect the
ElektraLite WW
from the power source, when the fixture is not in use or before
cleaning it. Only unplug
ElektraLite WW
from the power source holding onto the Edison plug. Never pull
out the Edison plug out by just pulling on the power cord itself.
Please keep the
ElektraLite WW
away from children and the general public. Please be intelligent and
use common sense when operating the
ElektraLite W W.
