PRODUCT SAFETY
• Children shall not play with the unit.
• Cleaning and user maintenance shall not be made by children without supervision.
• Please ensure the device is switched off when not in use.
• Do not use the device for other than its intended purpose.
• Do not use this product in bathrooms or other very hot or humid locations.
• Periodically check this product and its power supply for damage. If any is detected do not use
and contact your supplier.
• Do not leave this product switched on while unattended.
• The power supply MUST be kept in a well-ventilated area away from sources of heat and
moisture, such as a cooker and kettles.
INCLUDED IN THE BOX
1 x 6 puck lights 1 x Power supply with inline switch 12 x Wood screws
1 x Junction box 6 x Sticky pads
INFOMATION
•
Maximum lead length from the junction box to each light is 2m so try to mount the junction box
in the middle of the installation allowing for a span of up to 4m.
• While the product comes with both doubled sided sticky foam pads and wood screws in most
circumstances the pads on their own will usually be sufficient for permanent installation. Before
using the wood screws the installer should take care to make sure they are suitable.
• When using the sticky pads for installation make sure all surfaces are clean and clear of grease
and dust.
INSTALLATION
Fix Each Puck in place using either the sticky foam pads or wood screws. If using the screws
only use the two outer fixing points on the puck as per image below. Access to these can be
gained by unscrewing the top of the puck and removing the plastic diffuser. This should be
replaced after installation.
Wire each puck to the junction box as per the diagram below. When all of the pucks have been
installed connect the power supply to the junction box and switch on.
