Electrothermal MC5, Инструкция

Страница: 15 / 24

Page 15 of 24 M7044 iss 3.3
9.3.6. Replace the energy regulator control knob ensuring the flat on surface on the energy
regulator spindle is aligned.
9.3.7. Replace the base and refit the two fixing screws.
The responsible body shall check the electrical safety of the unit before further use.
9.4. Replacing the Neons.
9.4.1. Turn your product off and remove it from the mains supply. Disconnect it from any
heating resistive loads such as Heating Mantles, Heating Tapes and Cords.
9.4.2. Turn the Controller up-side down and remove the two fixing screws retaining the base.
Lift the base off.
9.4.3. Disconnect the two wires from the relavent neon.
9.4.4. Push the neon out from the inside. Note a slight twisting movement may be
necessary.
Reassemble.
9.4.5. Insert the new neon ensuring the tags align with the untouched neon.
9.4.6. Reconnect the tags.
9.4.7. Replace the base and refit the two securing screws.
The responsible body shall check the electrical safety of the unit before further use.