Introduction
The INF-WSM is a wireless sounder module designed for use with the infinite wireless control panel. This module
enables the infinite system to interface with most popular external sounders. The unit will be most suitably located
in the loft space, where a short hard-wired run to the external sounder and a 240V spur suitable for the low voltage
plug-in power supply can be most easily achieved.
Figure 1: INF-WSM (cover off)
Installation
1.
Remove the cover screws and lift the
front cover of the INF-WSM away
from the metal housing.
2.
Connect the antenna to the antenna
connector.
3.
Connect the four-pin terminal block to
the sounder as explained in the wiring
reference table that appears in the
following section.
4. Connect the backup battery to the
battery connector on the PCB.
5. To support the INF-WSM, the infinite’s main
board must have the plug-in transmitter installed.
Plug the on-board transmitter into the infinite
control panel’s main board as shown in Figure 3.
6.
On the receiver, press the Registration button
once to set the INF-WSM to Registration mode;
the Registration LED is lit.
7.
On the control panel, perform the External Siren
Test twice in order to register the control panel’s
transmitter to the INF-WSM’s receiver.
Upper
Mounting
Hole
Antenna
Connector
Lower
Mounting
Hole
Upper
Mounting
Hole
Lower
Mounting
Hole
Antenna
Cable
Entry Hole
Printed Circuit
Board (PCB)
Backup
Battery
Antenna
Connector
Registration
Button
Terminal
Block
SCE
Jumper
DC
Jack
Battery
Connector
Registration
LED
Figure 2: INF-WSM PCB
Figure 3: Plugging in the On-Board Transmitter
Содержание Infinite INF-WSM
Страница 1: ......
