3.
Setting and Unsetting
10
CommPact User Manual
3.
Setting and Unsetting
Setting can be defined as activating the system. When the system is set, it monitors the
zones that are protected by the detector. If a detector senses an intrusion, the system
generates an alarm.
3.1.
Setting Modes
Three setting modes are available: Full, Part and Perimeter. These modes enable you to
set your system accordingly to suit different circumstances.
You can only unset all the active setting modes.
Full Setting
Full setting activates the
entire system. This setting
method is used when you
intend to leave your home,
leaving the premises
empty.
Part Setting
This setting method enables
you to set a section of your
home while remaining on a
different part of the
premises.
Perimeter Setting
Perimeter setting enables
you to activate the
perimeter zones (the
windows and doors of your
home) enabling you to
move freely within the
protected area.
Certain detectors, such as smoke, carbon monoxide, gas and flood detectors, are
always active regardless of system status.
3.2.
Setting the System
Before setting the system, check that all doors and windows are secured so that the
system is ready for setting.
Setting with the Keypad
To set the system using the front panel/wireless keypads:
•
Press one of the three setting keys, the exit delay begins to count
down. At the end of the exit delay, the system is set.
