The material contained in this document is the property of Electronics & Innovation Ltd., it is
subject to change without notice.
August 2012 Page 9 of 10 Revision B
system design. Components, specifically on the RF driver board are prone to
over-heat and eventual failure if the unit is operated without the cover in place.
Ensure that the load is connected to the output prior to connecting the RF input
to the unit. This will prevent high voltages being present and exposed at the
output connector.
Only use the AC cord provided or equivalent.
Ensure that the mains outlet is properly grounded.
Figure 1
Gain Measurement
Figure 2
Power Meter
Sweep Generator
RF Output
500 KHz
– 1000 MHz
20 dB
Attenuator
Power Meter
