TC M Temperature Controller User Manual V1.08
Electron Dynamics Ltd page
13
7.7
Report
7.7.1
Set point
Displays the set point, can be used to ensure the controller has accepted the set point entered in the control
category; refer to
section 5.3
.
7.7.2
Temperature
Displays the measured temperature, the measured temperature units can be Celsius, Fahrenheit or Kelvin
and can be selected in the sensors category; refer to
section 5.4.3
7.7.3
Control
Displays the condition of the output drive either On or Off.
7.7.4
Output
Displays the output value is set to. Range 0 to +/- 1000
7.7.5
Alarms
Displays whether an alarm is active.
7.7.6
Faults
Displays any fault codes.
7.7.7
Temperature OK
Displays if the temperature is in the ok range
7.8
Reading and Setting Parameters
7.8.1
Read Button
The read button will load the respective GUI category with the current condition of the TC M Series
Temperature Controller
7.8.2
Write Button
The write button will load the TC M Series Temperature Controller with the current conditions entered in to
the GUIs category.
