Electrolux WAGL4E300, Руководство пользователя

Страница: 33 / 40

Problem Possible solution
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to 'Care and cleaning'.
Make sure that the water inlet hose has no kinks, damages
or bends.
Make sure that the connection of the water inlet hose is
correct.
The appliance fills with
water and drains imme‐
diately.
Make sure that the drain hose is in the correct position. The
hose may be positioned too low (see 'Water drainage' para‐
graph).
The appliance does not
drain the water.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Make sure that the drain filter is not clogged. Clean the fil‐
ter, if necessary. Refer to 'Care and cleaning'.
Make sure that the connection of the drain hose is correct.
Set the drain programme if you set a programme without
drain phase.
Set the drain programme if you set an option which ends
with water in the tub.
The spin phase does
not operate or the
washing cycle lasts lon‐
ger than usual.
Set the spin programme.
Make sure that the drain filter is not clogged. Clean the fil‐
ter, if necessary. Refer to 'Care and cleaning'.
Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance
problems.
There is water on the
floor.
Make sure that the couplings of the water hoses are tight
and there is not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the correct
quantity of it.
You cannot open the
appliance door.
Make sure that a washing programme that ends with water
in tub, has been selected.
Make sure that the washing programme is finished.
ENGLISH 33