Electrolux TW GL5 E, Руководство пользователя

Страница: 33 / 44

STARTING A PROGRAMME
To activate the programme push the button
as on the illustration. The LED above the
button illuminates in red colour.
CHANGE A PROGRAMME
To change a programme, push the On/
Off button to deactivate appliance. Push
the On/Off to activate the appliance and
then set the programme again.
AT THE END OF PROGRAMME
When the drying cycle is completed, the
symbol flashes on the display. If the Buzzer
(Signal) function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
1. Push the Auto/Off button for 2 seconds
to deactivate the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Important! After each drying cycle:
• clean the filter
• drain the water container
(See chapter
CARE AND CLEANING .)
HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry be-
comes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with a
coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the bot-
tom of the appliance clear.
• Use the load volumes which are specified
in the programmes chapter.
• Make sure that is good airflow in the ap-
pliance installation position.
• Clean the primary filter after each drying
cycle.
• Clean the heat exchanger filters when the
applicable indicator comes into the view
on the control panel.
• Spin good the laundry before drying.
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ-
ent locations. Water hardness has an effect
on the water conductivity and the operation
of the conductivity sensor in the appliance.
If you know the value of the water conduc-
tivity you can adjust the sensor to dry with
the better results.
To change the sensor conductivity:
1. Turn the programme dial to available
programme.
2. Push at the same time 2 buttons (see
the illustration). Hold down until one of
the symbols come into view on the dis-
play:
–
low conductivity <300 μ S/
cm
–
moderate conductivity
300-600 μ S/cm
–
high conductivity >600 μ S/
cm
electrolux 33