The wire which is coloured blue must be
connected to the terminal which marked with the
letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked the
letter L or coloured red.
If using a three-pin plug, do not make any
connection to the terminal marked with the letter
E or by the earth symbol
or coloured green or
green-and-yellow. This cleaner is double
insulated and no earth-connection is necessary.
It is in your interest to ensure that the plug is
correctly attached to the mains cable. In case of
doubt, consult a qualified electrician, as
Electrolux cannot regard the repair of faults on
the plug connection as a service that can be
given free of charge under the terms of
guarantee.
• Ensure the lengths of wire inside the plug are
prepared correctly.
• Connection should be firmly made after all
conductor stands are entered into the
terminal posts.
• When preparing the cable ends take care not
to damage the outer seal, or insulation
surrounding the inner conductors.
• Tighten all screws.
• Replace the top cover of the plug and secure.
A general guide to fitting any plug:
When using an electrical appliance, basic precautions should always be followed,
including
READ ALL THE INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
Do not use outdoors or on wet surfaces.
Do not leave the vacuum cleaner whilst plugged in.
Do not allow to be used as a toy. Close attention is necessary when used by or near
children.
Use only as described in this manual. Use only manufacturer's recommended
attachments.
Do not use with damaged cord or plug. If vacuum cleaner is not working as it should,
has been dropped, damaged, left outdoors, or dropped into water, contact Electrolux
Customer Services on 08706 055 055 before using.
Do not pull or carry by cord, use cord as a handle, close door on cord. Keep cord away
from heated surfaces.
Do not use extension cords or outlets with inadequate current carrying capacity.
Turn off all controls before unplugging.
Do not unplug by pulling on cord. To unplug, grasp the plug not the cord.
Do not handle plug or vacuum cleaner with wet hands.
Do not put any object into openings. Do not use with any opening block, keep free of
dust, lint, hair and anything that may reduce air flow.
Do not use to pick up anything that is burning or smoking, such as cigarettes, matches
or hot ashes.
Do not use without dustbag in place.
Use extra care when cleaning on stairs.
Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas
where they may be present.
Store your cleaner indoors in a cool, dry area.
Keep your work area well lighted.
Unplug electrical appliances before vacuuming them.
:
WARNING
To reduce the risk of fire, electric shock, or injury:
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS
ELECTRICAL SUPPLY
Before you start … check the voltage
Connecting to your electrical supply
Before connecting the cleaner to an electrical
supply ensure that voltage marked on the data
plate (beneath the cleaner) is correct for your
electrical supply. If it is not, do not use the cleaner
but refer back to your dealer.
Permanently connected to the cleaner is a mains
supply (2-core) cable fitted with a non-rewirable
plug incorporating a 13A fuse. In the event of the
fuse requiring replacement the fuse cover should
be removed using a small screwdriver. The old fuse
be replaced by a 13A ASTA approved
BS1362 fuse and the fuse cover must be replaced
before the plug is used again. In the event of loss of
the fuse cover, replacements can be obtained from
your Electrolux dealer or Electricity Board and must
be of the same colour as indicated by the coloured
insert on the base plug.
If difficulty is experienced in obtaining a
replacement, contact your nearest Electrolux
Service Centre.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off and
the appropriate plug fitted. Remove the fuse from
the cut off plug. The cut off plug should then be
disposed of to prevent hazard of shocks in case it
should be plugged into a 13 Amp socket in another
part of your home.
As the colours of the wires in the mains cable of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
MUST
In no circumstances must be plug be used
without a correct fuse cover fitted.
The wires in the mains cable of this appliance
are coloured in accordance with the following
code:
Blue:
Neutral.
Brown: Live.
IFU inside of 21-serie
- -
4
- -
1
