For any request for information or to order spare parts,
stipulate the type of machine, the serial number and the
electrical characteristics.
4
T8E GB 05 2012
6
.2 EQUIPMENT MAINTENANCE
•
ABRASIVE PLATE /AND BOWL
:
In the event of a lack of efficiency:
- Deteriorated abrasive (failure to renew vegetables and for-
mation of flats): Change the plate or the bowl.
- Plate fouling (deposits of limestone, soil and starch): Brush
the plate clean and the bowl.
6.
3
ELECTRIC COMPONENTS
See the circuit diagrams at the end of the manual
•
Wire color identification:
- Power circuit: black
- Control circuit: red
- Phases:
L1
- Neutral
N
- Ground
B/C green/yellow
•
Component identification:
0
:
OFF pushbutton
I
:
ON pushbutton
M
:
Motor
CPu :
Power board
CC :
Control board
Rt
:
Time delay relay
CD :
Starting capacitor
CP :
Permanent capacitor
R
:
Starting relay
6.
4
MAINTENANCE ADDRESS
As a priority, we suggest that you get in touch with the machine
vendor.
The manufacturer reserves the right to modify and improve
products without prior notice.
Dealer’s stamp:
Date of purchase: .............................................
6.
3
Maintenance
6.
1
MECHANISM
• This peeling machine requires minimum maintenance (the
motor bearings and those of the mechanism are greased for
life).
• At least once year, it is advisable to check the wear of the
belt.
• To gain access to the mechanism, motor and electronic com-
ponents:
- Disconnect the machine.
- Turn it over and remove the 5 screws attaching the bottom
and the control box.
• The capacitors may conserve an electric charge. To avoid
any risk on Maintenance, it is advisable to discharge them by
connecting their terminals using an insulated conductor (e.g. a
screwdriver).
• Changing belts:
- Unscrew the 4 attaching screws of the motor bracket (Philips
head screwdriver).
- Approach the motor and slide it onto the drive pulley to remove
it.
- Fit a new belt.
- Tension the belt slightly, using a screwdriver as a lever (passage
hole in motor support).
- Lock the 4 motor support attaching screws.
Always disconnect the machine before any intervention on it.
