20
E10
appears.
END indicator flashes 1x,
at the same time an
acoustic signal sounds
1x.
(Problems with water in-
flow.)
Tap turned off.
Turn the tap on.
Filter in the screw connection
of the inlet hose is blocked.
Turn off the water tap. Unscrew
hose, take out filter and clean it.
Water tap is blocked with
limescale or faulty.
Check the water tap and have it
repaired if necessary.
Washing machine vi-
brates when operating or
is noisy.
Transport lock has not been
removed.
Remove transport lock.
Screw feet not correctly ad-
justed.
Adjust feet according to the In-
stallation and Connection in-
structions.
Washing has not been
spun.
Only a few large items of
washing in the drum.
Always load the drum as full as
possible. Mix large and small
items.
Water is leaking out un-
derneath the washing ma-
chine.
Screw connection on the inlet
hose is leaking.
Tighten inlet hose.
Drain hose is leaking.
Replace drain hose.
Drain pump cover is not
closed properly.
Close cover properly.
Washing was caught in the
door.
Load washing carefully for the
next wash.
Emergency drain hose is leak-
ing.
Close off emergency drain hose
properly.
EF0
appears. END indica-
tor flashes 15x, at the
same time an acoustic
signal sounds 15x.
The drain pump runs con-
stantly, even when the
machine is switched off.
The Aqua Control anti-flood
system has responded.
Turn off the tap, remove the
mains plug from the socket and
contact the Customer Care De-
partment.
Washing water is foaming
excessively. At the
end
of
the washing cycle, the
spin stops. OVER DOS-
ING indicator is lit.
Probably too much detergent
has been used.
Dose detergent exactly as in-
structed by manufacturer.
Problem
Possible cause
Remedy
